734-662-2102 or


Pro Street, 1963 Jaguar XKE

This Jaguar XKE has been modified to a pro street format. A full roll cage and safety equipment wraps the 455 cubic inch Chevrolet motor which bolts to a torque flight transmission. A narrowed Dana 60 puts the power to the ground. The body and frame have been handcrafted to give the Jaguar a solid pro street platform. The Mustang II front end gives the car some stabililty with its stiff ride. This car is set up to go fast and straight, a head turner for sure. Has had centerfold attention in magazines.

Paint: Porsche Indian Red
Interior: silver/grey
Engine: 1974 unleaded 454 Chevy, 9.0:1 compression
Induction: Holley 800 cfm Spread bore
Exhuast: Hand made headers and chambered pipes
Transmission: Chevy Turbo 400 with B and M shift kit
Rear End: Dodge Dana 60 with 3:55 posi-trac
Front wheels: 15x5 Superior TRC
Rear Wheels: 15x12 Superior TRC
Front Suspension: Mustang II (A-arms, brakes, rack and pinion with adjustable Koni coil over shocks
This car was featured in the March 1986 issue of CarCraft Magazine


1970 Eliminator Clone

  • 428 Cobra Jet
  • 4 Speed Toploader
  • Competition Gold Paint
  • Ginger Houndstooth Interior
  • Hayden Electrical Fans
  • MSD 7AL Ignition system
  • Oil Cooler
  • Sub Frame Connected
  • Monte Carlo Bar
  • Intrax Lowering Springs
  • Hooker Headers
  • High Torque Starter
  • MSD Redy to run Distributor
  • MSD 7AL Ignition with two step module and rev control
  • Holley 750 Dbl.Pumper
  • Flowmaster Mufflers
  • New Lines and Hoses
  • Stewart Warner

1969 Mercury Cougar XR7

1969 Mercury Cougar XR-7, cobalt blue with blue leather. It rides approximately 2.5 inches lower than stock on heavy-duty road race suspension. The finish is Dupont Chromabase in cobalt blue. This car has been restored and reconditioned with the following list of parts and details.

Engine
  • 351 Windsor
  • Federal Mogul bearings
  • Speedpro rings
  • Melling oil pump
  • Milodon oil pan (8 qt.)
  • Milodon high volume water pump
  • Edelbrock Victor Jr. intake
  • Comp Cams retro-fit roller cam Roller lifters
  • Double valve springs
  • Chrome moly push rods
  • Probe industries forged pitons
  • Harland sharp roller rockers
  • Hooker super comp headers
  • Cloyes double roller chain
  • Hardened oil pump drive
  • Accel 300 + ignition
  • Fel-Pro gaskets